puldi lisamine. explorer



To program the hand held remotes:
 Unlock all doors using the power door lock/unlock control. 
Insert a key and turn the ignition from the 1 (OFF/LOCK) to the 3 (ON) position 
and cycle between 1 (OFF/LOCK) and 3 (ON) eight times in rapid succession (within 10 seconds) 
with the eighth turn ending in the 3 (ON) position. 
The locks will cycle to confirm that the programming mode has been entered. 
Within 20 seconds, program a remote transmitter by pressing any button on a transmitter. 
The locks will cycle once to confirm that the remote transmitter has been programmed. 
(If more than 20 seconds pass before pressing a remote transmitter button, 
the programming mode will exit and the procedure will have to be repeated.) 
Repeat the previous step to program additional remote transmitters. 
NOTE: All fobs must be programmed on the same time for all fobs to work. 
The locks will cycle once to confirm that each remote transmitter has been programmed. 
When you have completed programming the remote transmitters, 
turn the ignition to the 1 (OFF/LOCK) position or wait 20 seconds. 
Again the doors will lock/unlock to confirm programming has been completed.